FUTABA T26SZ - Page 189

189
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
＊ Gyrogainchannel
Gyro:CH5
FortheFASSTest12CH,Gyro/RUDis6ch.Thegyrosensitivityadjustmentconnectorconnectsto6ch.
＊ Gyrogainchannel
GyroRUD:CH5 FortheFASSTest12CH,Gyro/RUDis6ch.
Gyro2AIL:CH9
Gyro3ELE:CH10 FortheCGY750,simplyconnecttheS.BUS;functionsdonotneedtobeset.
(FortheFASSTest12CH,changeGyron/RUDto6ch.)
Usageexample#1:Usinggyroforonlytherudderandadjustingsensitivityforeachcondition
Usageexample#2:Using3-axisgyroCGY750andadjustingsensitivityforeachcondition
Becausesensitivitychangesforhovering
andidleup,performswitchoverforeach
conditionandadjustsensitivity.
Becausesensitivitychangesforhovering
andidleup,performswitchoverforeach
conditionandadjustsensitivity.
Becausethesensitivity
isswitched(Sngl)per
condition,Rate2and
Rate3arenotused.
Becausethesensitivity
isswitched(Sngl)per
condition,Rate2and
Rate3arenotused.
Tappingherewillletyou
selecteitherNormalor
AVCSforeachofthethree
axes.
Thisisallthatisneeded
foruseinthiscase.
Thisisallthatisneeded
foruseinthiscase.
Tappingherewillletyou
selecteitherNormalor
AVCS.
Setgainofarudder
Setgainofarudder
Setgainofanaileron
Setgainofanelevator
ŏ6HOHFW>*\UR@DWWKH
model menu and call
the setup screen.
ŏ6HOHFW>*\UR@DWWKH
model menu and call
the setup screen.