FUTABA T26SZ - Page 188

188
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
ŪƜƕƒؙžūƈƏƌƆƒƓƗƈƕƀ
Usethiswhenyouwantto
adjustsensitivityviaVR,
etc.,andnoton-screen
dataentry.Tap"--",select
"VR",etc.,andthentap
thevaluetoadjust.(Won't
operatewhenvalueis"0".)
Theoperationmode
(AVCS/NOR)and
sensitivityofthe3axes
Gyro/Gyro2/Gyro3can
beset.
Tappingthesewill
pullupthedetailed
selectionscreenfor
each.
Rate1Gyrotypeand
gain
Rate2Gyrotypeand
gain
Rate3Gyrotypeand
gain
TheON/OFFswitchof
gyroischosen.
WhenusingRate2/Rate3,makeit
INH → ONorOFF.
Gyro（RUD)
setting
Gyro2（AIL)
setting
Gyro3（ELE)
setting
3rate(gyrogain)
adjustment
Conditiongroup/
singlemodeselection
(Gr./Sngl)
This function is used to adjust gyro sensitivity. The
sensitivity and operation mode (Normal mode/
AVCS mode) can be set for each condition.
The gyro sensitivity can be switched with each
condition or the switch. (3 sensitivities)
*Compatible with 3 axis gyro.
ŶƈƗƗƌƑƊŃƐƈƗƋƒƇ
ŏ :KHQXVLQJWKLVIXQFWLRQ7DS>,1+@21LV
displayed.)
ŏ :KHQ\RXZDQWWRVHWWKHVDPHFRQWHQWVDWRWKHU
conditions, select the group mode.
When you want to set the selected condition only,
select the single mode (initial setting).
ŏ 7KUHHUDWHVFDQEHVZLWFKHGIRUHDFKFRQGLWLRQ
(Rate 1/Rate 2/Rate 3)
ŏ $ÀQHWXQLQJ95FDQEHVHW
ŏ6HOHFW>*\UR@DWWKH
model menu and call
the setup screen.
Note: [Gyro] [Gyro2] [Gyro3] Default function
[Gyro]: CH6(FASSTest12CH) CH5(Other system type)
[Gyro2] : CH9
[Gyro3] : &+
Always set to [--] both (control) and (trim) for
the [Gyro] function at the Function menu in
the Linkage menu.
ŏ5HWXUQWR0RGHOPHQX