FUTABA T26SZ - Page 21

21
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
ŵƈƏƈƄƖƈŃƒƉŃƖƓƕƌƑƊŃƗƈƑƖƌƒƑ
7KHVSULQJWHQVLRQFDQEHUHOHDVHGE\WLJKWHQLQJWKHVFUHZLQWKH¿JXUHEHORZ
e.g.Stickmode2 → Stickmode1
Backside
Loosen the screws
for
both of them.
For airplanes: Adjust the screw
on the right.
For helicopters: Adjust the
screw on the left.
Tighten this screw to release
the spring tension.
Whenthisstickmodeischanged,the
modeldataisreset.
Changestickmodebeforeentering
modeldata.
WARNING
Beforetheflight,makesurethatthe
operationofthestickmatchesthe
modeloperation.
Systemmenu ⇒ H/Wsetting
Selectstickmode
Calibrationrequiredafter
changedthestickmode.
Loosen this screw and
add spring tension.