FUTABA T26SZ - Page 22

22
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
ŧƌƊƌƗƄƏŃƗƕƌƐƖŃŷŔŐŷř
This transmitter is equipped with 6 digital trims.
Each time you press a trim button, the trim position
moves one step. If you continue pressing it, the trim
position starts to move faster. In addition, when
the trim position returns to the center, the tone will
change. You can always monitor trim positions by
referencing the LCD screen.
*You can select the trim step amount and the display unit
on the home screen on the T1-T6 setting screen within the
linkage menu.
Note: The trim positions you have set will be stored in the
non-volatile memory and will remain there.
T1T4
T3
T6
T2
T5
ŰƒƑƌƗƒƕŃůŨŧŃƌƑƇƌƆƄƗƌƒƑ
The status of the transmitter can be monitored by LED indicator built-in the power switch.
◆ Charging→RED(Chargingcompletion →TurninglightsOFF)
◆ FASSTestmode→LightBLUE
◆ T-FHSSAIR/S-FHSSmode→YELLOW
◆ RF-OFF→VIOLET
◆ Starting→RED
◆ TrainerStudent→BLUE
◆ Rangecheckmode→Blinkslowly
◆ Linkmode → Blinkfast