EasyManua.ls Logo

FUTABA T26SZ - Page 210

FUTABA T26SZ
248 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
210
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
GyrosettingCGY770R
GovernorBasic
GovernorBasic
(11) SenseTyp: Sensor type
Selectthetypeofgovernorsensor.
Nitro(BPS-1backplate;MagnetType)
1:1Magnet"1:1Magn"(Magnettypeappliedtohelicopterpartthatturns
atthesameRPMasthemainrotor)
HPoleEP:ForElectricmotors8polesandabove
LPoleEP:Forelectricmotors6poles.
(12) GOV Gain: Governor gain
GovernorGain.IfthevalueoftheGovernorGainissettoolow,theheli-
copter'sRPMwillfluctuatewithcollectiveandcyclicpitchchanges.Con-
versely,ifthenumberistoohigh,theRPMitselfwillfluctuateandsurge
duringflight.
Settingranges:1~100%
Initialvalue:Nitro=40%,1:1Magn=60%,HPoleEP=30%,LPoleEP=10%
Cond
(13) L Lmt. L rpm / H rpm: Low limit RPM
LowRPMLimitsetstheminimumamountofthrottlethatthegovernor
willcommandduringanover-speedsituation.Toolowofvaluetheen
-
ginecouldshutoffornotrecoverpowerquicklyenoughduringthenext
collectivemovement.Ifthevalueissettoohigh,thegovernorwillnot
controloverspeedwhentherotorheadisunloaded.
Use:
LLmt.Lrpm:ForRPMSof700-1700
LLmt.HrpmForRPMSof1701-4000
Settingranges:LLmt.L
rpm=0~80%,LLmt.H
rpm=10~80%
Initialvalue:LLmt.L
rpm=25%,LLmt.H
rpm=45%
Cond
(14) SBUS2 rpm out: RPM display on transmitter
Whendisplayingtherpmwiththetelemetryfunction,setittoACT.
Setting:ACT(Active)/INH(Inhibit)Initialsetting:INH
(15) SBUS2 rpm Slot: RPM display on transmitter
Settheslotnumberofthetelemetryrotationsensorregisteredonthe
transmitterside.
Thismustbesetsothatnoslotsoverlaponeanother.
(16) Rev. Sensor: Revolution sensor testing
Thismenuisutilizedtoensurethattherevolutionsensorisfunctioningproperly.
Inordertotestthesensor,doNOTstarttheengine.Instead,werecommendturningtheengineoverbyhandortheutilizationofastarter.Topreventinadver
-
tentignitionoftheengine,doNOTuseaglowplugigniterwhenturningtheengineover.
Thenumericalvaluesontheleftsideofthedisplayarethecurrentvalue.Therightsideofthedisplayindicatesthemaximumsensorvalue.Theoutputlevel
needstobemorethan60%forcorrectgovernoroperation.Also,whenusingthebackplatesensor,thesignallevelofthebackplatesensorvariesdependingon
therotationspeed(3,000
rpmormoreisthedetectablerotationspeed).
Bythetelemetryfunction,thenumberofrevolutionsreadbythegovernorsensorcanbedisplayedonthemonitorofthetransmitter.Inordertobeabletodisplay,activatethetelem-
etryrotationsensor(SBS-01RM)onthetransmitterandsetthegearratioto1.00.
Note:ItcannotbeusedwhenthetransmitterisFASSTest12
CHsystem.

Related product manuals