FUTABA T26SZ - Page 213

213
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
GyrosettingCGY770R
RudderExpert
RudderExpert
(3) CNT. DlIn: Control delay in
Thisparametersetsthedelayasyoumovethestickfromneutraltoward
leftorright.Largervaluesresultinasoftertailrotorfeeloffcenter.This
parametermustbeadjustedindividuallyforLEFTandRIGHTtailrotor
commands.Followthesesameprocedurestoadjustthetailrotorfeelin
theoppositedirection.
[Settingmethod]
MovethetransmitterRudderstickrightorleftinthedirectionyouwant
toset.Touchthegreenbuttontoenterthesettingmodeandsetthede
-
layamount.Dothesamefortheotherside.
Settingranges:0~20  nInitialvalue:15  n
(4) CNT. DlOut: Control delay out
Thisparametersetsthedelaywhenthestickisreturnedbacktothe
neutralposition.Thisparameterisusefultotunehowaggressivelythe
tailrotorstopsfollowingapirouette.Thehigherthevalue,thesofterthe
stop.Thisparametermustbeadjusted individuallyforLEFTandRIGHT
tailrotorcommands.Thesettingmethodisthesameas"CNT.DlIn",so
pleaserefertotheinformationabove.
Settingranges:0~20  nInitialvalue:12  n
(5) ANG: Pirouette speed
Thisparameteradjuststhemaximumpirouettespeedofthetailrotor
thatthegyrowillallowat100%dualrate.
Settingranges:100~999  dInitialvalue:=720  d,