FUTABA T26SZ - Page 245

245
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
7. When the software update is completed,
"Completed" message is shown on the LCD display
of your T26SZ. (Show below picture.)
8. Turn off the power switch of your T26SZ and remove
the microSD card from the card slot.
Possible Problems
When one of the error messages shown below
appears on the LCD screen your T26SZ, the
software update will not be completed.
"Low battery."
Software update is postponed because of low
battery. Retry the software update after the
battery is recharged.
8SGDWHÀOHQRWIRXQG
The T26SZ cannot find the update file on the
microSD card. Check to be sure all the update
ÀOHVKDYHEHHQFRSLHGRQWRWKHPLFUR6'FDUG
%URNHQÀOH
The T26SZ detects the update file error. The
update file may be broken or for another
transmitter.
"Write error."
The software update procedure is stopped for
an unknown reason. Contact your local service
center when this error message appears on the
LCD screen of your T26SZ.
Don't absolutely remove the battery and
the microSD card from the transmitter
during the update.
There is a possibility that the transmitter will be
damaged.
Recovering a failed update
If you failed to update for any reason, it may
transmitter will not start.
In that case, please update again transmitter
in the following procedure.
1. Detach the battery from the transmitter.
2. Insert the microSD card that contained the
XSGDWHÀOHVWRWKHWUDQVPLWWHU
3. Attach the battery to the transmitter while
pressing down the "EXIT" button.
4. The update will start.
Even after the above steps, if the transmitter
fails to update or does not start, please have it
serviced.
Complete