FUTABA T26SZ - Page 246

246
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
ŷŔŗŶŪŒũŻŐŕŕŒŷŔŕŮŃڀ ŷŕřŶŽŃŰŲŧŨůŃŧŤŷŤŃŦŲűŹŨŵŶŬŲű
The model data (only latest version) of T14SG/FX-22/T12K can be copied to T26SZ.
* microSD card is required.
* The model data of T26SZ cannot be copied to T14SG/FX-22/T12K.
* Use an SD card conversion adapter (not included) to insert a microSD card into the T14SG/FX-22/T12K.
* The data read from the gyro will be initialized. Reread from the gyro.
* Telemetry data is initialized.
[Model data conversion method]
1. Attach a microSD card that contains model
data of T14SG/FX-22/T12K to the SD slot of a
T26SZ.
2. Turn on the power switch, and the Data
Converter should run.
3. The converter shows a list of model data in
the card. Select a model data that you want
to convert and push "CONVERT"
→
"Yes" key,
and the converter should begin converting
data.
4. If the convert succeeds, the converter will
show the following message. The converted
data are copied to the internal memory
of the T26SZ. Hence, if the T26SZ does not
have available space in its internal memory,
converts must fail.
* When microSD card cannot be recognized, it may be able
WREHXVHGLILWUHIRUPDWVE\6'IRUPDWWHUR൵HUHGIURP6'
Association.
SD formatter is downloadable from SD Association
https://www.sdcard.org/
&$87,21
Afterfinishingdatacopy,besureto
performacompletecheckofoperation
withthemodeltobeused.
Checkwellallthedirectionsofoperation
andalltheoperationswitches.
5. The converter can accept model data
made by T14SG/FX-22/T12K with the latest
software only. If you try to convert model
data made by old version software, the
converter must fail to convert and show
the following error message. If this message
is shown, do the following procedure to
update the model data in order to avoid
this limitation.
(a) First, update a T14SG/FX-22/T12K to the latest software.
(b) Load the model data which failed to convert into the
T14SG/FX-22/T12K with the latest software, and the
model data should be updated to the latest format.
(c) Save the updated model data to a microSD card.
(d) Retry to convert the updated model data on a T26SZ.