FUTABA T26SZ - Page 36

36
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
ŵƄƑƊƈŃƗƈƖƗƌƑƊŃƜƒƘƕŃŵŒŦŃƖƜƖƗƈƐŃ
It is extremely important to range check your models prior to each flying session. This enables you to
HQVXUHWKDWHYHU\WKLQJLVIXQFWLRQLQJDVLWVKRXOGDQGWRREWDLQPD[LPXPHQMR\PHQWIURP\RXUWLPHÀ\LQJ
The T26SZ transmitter incorporates a system that reduces its power output and allows you to perform such
a range check.
ŵƄƑƊƈŃƆƋƈƆƎŃƐƒƇƈŃ
During this mode, the RF power output is reduced so the
range test can be performed. In addition, when this mode
is activated the right LED on the front of the transmitter
starts blinking and the transmitter gives users a warning
with a beeping sound.
The "Range check mode" continues for 60 seconds and
after that the power will return to the normal level. To
exit the "Range check mode" before the 60 seconds,
SUHVVWKH(;,7EXWWRQ1(9(5VWDUWÀ\LQJZKHQWKH
"Range check mode" is active.
Should you require additional time to perform a range
check, highlight Restart before your time expires and tap
the screen one time.
ŵƄƑƊƈŃƆƋƈƆƎŃƓƕƒƆƈƇƘƕƈ
1.
With the "Range check mode" on, walk away from the
model while simultaneously operating the controls.
Have an assistant stand by the model to confirm that
all controls are completely and correctly operational.
You should be able to walk approximately 30-50 paces
from the model without losing control.
2.
If everything operates correctly, return to the model.
Set the transmitter in a safe, yet accessible, location
so it will be within reach after starting the engine or
motor. Be certain the throttle stick is in the low throttle
position, then start the engine or motor. Perform
another range check with your assistant holding the
aircraft with the engine running at various speeds. If
the servos jitter or move inadvertently, there may be
a problem. We would strongly suggest you do not fly
until the source of the difficulty has been determined.
Look for loose servo connections or binding pushrods.
Also, be certain that the battery has been fully charged.
About100feet
Rangecheckmode
Rangecheckingon
lowpower.
WARNING
Donotflyintherangecheckmode.
Ŷ6LQFHWKHUDQJHRIWKHUDGLRZDYHVLVVKRUWLIWKH
model is too far from the transmitter, control will be
lost and the model will crash.
2.
THR Stick Slow.
1.
While pushing "U.MENU" button.
4.
Select "Range check" at the System menu.
5.
"Start"tap.
6.
The EXIT button is pressed to end a
range check.
3.
T26SZ Power ON.
t
1
00
feet