FUTABA T26SZ - Page 49

49
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
ųƕƒƆƈƇƘƕƈŃƉƒƕŃƆƋƄƑƊƌƑƊŃŶőťŸŶŃƖƈƕƙƒŃ
ƖƈƗƗƌƑƊ
1. Select [S.Bus servo] of the System menu.
:LUHWKHVHUYRDVVKRZQLQWKHÀJXUHDERYH
3. Press [Read]. The ID and current setting of that
servo are displayed.
4. Set each item. (Refer the next page.)
5. Press [Write]. The settings are changed.
ŶőťƘƖŃƖƈƕƙƒ
S.BUS servo setting
●
Call the following setting screen by pressing the [S.BUS
Servo] button in the System menu.
ٴ ŶƈƕƙƒŃŬŧŃƑƘƐƅƈƕ
If you use multiple S.BUS servos, only the desired
servo in the group can be set by entering the ID of
WKDWVSHFL¿FVHUYR
An S.BUS(2) servo can memorize the channel and
various settings you input. Servo setting can be
performed on the T26SZ screen by wiring the servo
DVVKRZQLQWKH¿JXUH
* With some S.BUS(2) servos, there are some functions which
cannot
be used. If a function cannot be used, the display
screen will change. (Only the function which can be used
by
a servo is displayed.)
*
After reading completion, with connection of the above
¿JXUHLIDVWLFNLVPRYHGVHUYRRSHUDWLRQFDQEHWHVWHG
●
Return to System menu