FUTABA T26SZ - Page 50

50
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
S.BUS/S.BUS2
Servo
3-way hub or
Y-harnesses
ūƒƚŃƗƒŃƕƈƄƇŃƗƋƈŃƖƈƕƙƒŃŬŧŃƑƘƐƅƈƕŃƚƋƈƑŃƐƘƏƗƌƓƏƈŃƖƈƕƙƒƖŃ
ƄƕƈŃƆƒƑƑƈƆƗƈƇ
Each S.BUS servo has an ID number stored in it.
$VVKRZQLQWKH¿JXUHRQWKHULJKWWKH,'VRIPXOWLSOHVHUYRVLQVWDOOHGRQ
the aircraft can also be read and displayed in a list.
1. Select [S.Bus servo] of the System menu.
:LUHWKHVHUYRDVVKRZQLQWKHÀJXUHDERYH
3. INH
→
ACT
4. Press [Read]. The ID and current setting of that servo are displayed.
5. Tap the Ch number of the servo you want to adjust, or
enter the displayed ID and then tap [Read] to read the
settings of that servo to the transmitter.
6. Set each item. (Refer the next page.)
7. Press [Write]. The settings are changed.