FUTABA T26SZ - Page 60

60
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
＜or＞
ŰƒƇƈƏŃƖƈƏƈƆƗ
The Model selection function performs model addition, call,
deletion, copy, and model name setting.
This function is used to load the settings of the
desired model into the T26SZ’s memory.
The settings may be selected from either the
transmitter’s built-in memory. Remember that up to
30 model memories are available in the transmitter.
The model data of the microSD card is for storage.
microSD card model data cannot be called directly
from the transmitter. The name of the model stored
in the transmitter and the microSD card may be
changed. This can be very useful to tell different
models settings apart. Each model name can be as
long as 15 characters, and the model name always
appears in the display screen.
The Copy function is used to copy one set of model
data into a second memory within the transmitter
and the microSD card. It may be used for getting
a head-start on setting up models with almost the
VDPHVHWWLQJVRQO\GL൵HUHQFHVQHHGWREHPRGL¿HG
instead of entering the complete model from
scratch). Also, this function may be used to make a
backup copy of a model setup before any changes
are made.
●
Select [Model select] at
the linkage menu and call
the setup screen shown
below.
ŰƒƇƈƏŃƄƇƇƌƗƌƒƑ
1. Tap the [New] button.
2. Tap [Yes] to add the model. (When you want to
cancel model addition, tap [No].)
*The added model is displayed in the model list.
*When a model is added, a receiver link is required.
● "Saveto"
 [Internal]:transmitter
memory
 [SDcard]:microSDcard
●
Return to Home or
Linkage menu
Currentmodelis
green.
●Tapthe[Modelselect]
buttonintheHomescreen
tocallthesetupscreen
shownbelow.