FUTABA T26SZ - Page 59

59
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
●Longpressthe[U.MENU]
buttonintheHomescreen
tocallthesetupscreen
shown.
＜or＞
Eachchannelmovementcanbechecked.
[Neutral]:Modewhichlockseachservointhe
neutralposition
[Moving]:Modewhichrepeatsoperationof
eachservo
ŶƈƕƙƒŃƐƒƑƌƗƒƕ
Servo Test & Graph Display / Displays servo positions.
This is used for testing servo movement. “Moving
Test” (repetition mode) and “Neutral Test” (fixed
position mode) are available.
7KH³1HXWUDO7HVW´LVJRRGIRU¿QGLQJWKHQHXWUDO
position of a servo horn.
In order to prevent any potential difficulties,
the servo test function will be inoperable, or
LQDFFHVVLEOHXQGHUFHUWDLQFRQGLWLRQV6SHFL¿FDOO\
the Servo Test function is not operational if the
Throttle cut is ON in either airplane or helicopter
modes; or if the Throttle hold is ON in helicopter
mode.
●
Select [Servo monitor] at the linkage menu
and call the setup screen shown below.
WARNING
Don'tsetaservotestmodewhenthe
drivemotorisconnectedandthe
enginehasbeenstarted.
Ŷ,QDGYHUWHQWURWDWLRQRIWKHPRWRURUDFFHOHUDWLRQRIWKH
engine is extremely dangerous.
●
Return to Home or
Linkage menu
EXITbutton
orselect[OFF]
Testingis
stop
Taptogoto2/2page
Testmodechange:
OFF → Neutral → Moving