FUTABA T26SZ - Page 66

66
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
Tapthevaluesyou
wishtoadjustand
valueinputbuttonswill
appearon-screen.
Travelrate Limitpoint
Nextpage
Ch7-16
Left/Top Right/Bottom
30 〜
140%
30 〜
140%
Indicatesthecurrent
directionofthestick,etc.
●
Tap the [End point] button in the Linkage
menu to call the setup screen shown
below.
ŨƑƇŃƓƒƌƑƗ
Sets the travel, limit point.
(The display screen is an example. The screen depends on the model type.)
The End point function adjusts the left and right
VHUYRWKURZVJHQHUDWHVGL൵HUHQWLDOWKURZVDQGZLOO
correct improper linkage settings.
The travel rate (normal full stick movement at high
rates) can be varied from 30% to 140% in each
direction on channels 1 to 16. Also, the limit point
(how far the servo travels when a mix is involved)
where servo throw stops may be varied from 0% to
155%.
ŶƈƕƙƒŃƗƕƄƙƈƏŃƄƇƍƘƖƗƐƈƑƗ
1. Tap the travel button of the channel you want to
set. Value input buttons appear on the screen.
2. Use these buttons to adjust the rate.
ŏ,QLWLDOYDOXH
ŏ$GMXVWPHQWUDQJHa
3. Repeat the procedure above for each rate.
ůƌƐƌƗŃƓƒƌƑƗŃƄƇƍƘƖƗƐƈƑƗ
1. Tap the limit button of the channel you want to set.
2. Use the value input buttons to adjust the limit point.
ŏ,QLWLDOYDOXH
ŏ$GMXVWPHQWUDQJHa
3. Repeat this procedure for each limit point.
●
Return to Linkage
menu