FUTABA T26SZ - Page 67

67
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
ŶƈƕƙƒŃƖƓƈƈƇ
Sets the speed of each servo.
The Servo speed setting is used to set the servo
delay for each channel, from channel l to channel
16. The system uses the programmed speed (delay)
to slow down servo position changes. The Servo
ŶƈƕƙƒŃƖƓƈƈƇŃƖƈƗƗƌƑƊ
1. Tap the speed button of the channel you want to
set.
2. Use the value input buttons to adjust the servo
speed.
ŏ,QLWLDOYDOXH
ŏ$GMXVWPHQWUDQJHaVWHSV
speed setting can be varied from 0 to 27 in each
channel.
●
Tap the [Servo speed] button in the Linkage menu to
call the setup screen shown below.
3. Repeat this procedure for each channel.
To close this screen, tap the [Servo speed]
button.
●
Tap the [Sub-trim] button in the Linkage menu to call
the setup screen shown below.
ŶƘƅŐƗƕƌƐ
Setting of neutral position of each servo.
The Sub-Trim function is used to set the servo
neutral position, and may be used to make fine
adjustments to the control surface after linkages
ŶƘƅŐƗƕƌƐŃƄƇƍƘƖƗƐƈƑƗ
1. Tap the trim display part of the channel you want
to adjust.
Value input buttons appears on the Sub-trim
menu screen.
and pushrods are hooked up. When you begin to set
up a model, be sure that the digital trims are set to
their center position.
2. Use the value input buttons to adjust the sub trim.
ŏ,QLWLDOYDOXH
ŏ$GMXVWPHQWUDQJHaVWHSV
*See above
3. Repeat this step for each channel.
●
Return to Linkage menu
●
Return to Linkage menu
（First）0 〜 27（Slowly）
（First）0〜27（Slowly）