FUTABA T26SZ - Page 73

73
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
7HOHPHWU\IXQFWLRQ)$667HVW7)+66$,5PRGHRQO\
To use the telemetry function, set “Telemetry” to “ACT”.
'/,QWHUYDO)$667HVWPRGHRQO\
When a telemetry function is enabled, the receiving
interval (down-link interval) of sensor data can be
changed.
If a DL interval is increased, the response of the
sensor data display becomes slower, but stick
response will improve.
Systemtype
■ FASSTest26CH---FASSTestsystemreceivermode.Applicablewiththetelemetrysensorunit.
Upto26channels(linear24+ON/OFF2)canbeused.
■ FASSTest18CH---FASSTestsystemreceivermode.Applicablewiththetelemetrysensorunit.
Upto18channels(linear16+ON/OFF2)canbeused.
■ FASSTest12CH---FASSTestsystemreceivermode.Applicablewithreceivervoltagedisplay.
Upto12channels(linear10+ON/OFF2)canbeused.TelemetrySensorcannotbeused,but
theresponsespeedisfasterthanthatofthe26/18CHmode.
* AnalogservoscannotbeusedwiththeR7208SB(R7308SB)intheFASSTest12CHmode.
■ T-FHSSAIR---T-FHSSAIRsystemreceivermode.Applicablewiththetelemetrysensorunit.
Upto18channels(linear16+ON/OFF2)canbeused.
■ S-FHSS---S-FHSSsystemreceivermode.Upto8channelscanbeused.
ŦŵŶũŃųƕƒƗƒƆƒƏŃƉƒƕŃŷťŶ
T26SZ has been made compatible with the CRSF
(TBS) protocol.
*Bidirectional communication function of CRSF is not supported.
*When using CRSF, the S.BUS servo setting function and
[Reload] [Register] [Change slot] functions cannot be used.
When setting S.BUS servo and sensor, set CRSF to INH.
Tapthe"CRSF"buttonto[ON].Asignal
conformingtotheCRSFstandardis
outputfromtheS.BUSsettingconnector
(S.I/F)ofthetransmitter.
WARNING
Futabaisnotresponsiblefordamage
sustainedby combinationwith
partsotherthanFutabaGenuine
equipment.
●
Call page 2/2 from the [System type] menu.
WhentheCRSFfunctionisON,functions
connectedtoS.I/Fconnectorssuchasservos
cannotbeused.Ifopenascreenthatusesthe
S.I/FconnectorwhentheCRSFfunctionisON,
anotificationscreenwillbedisplayed.