FUTABA T26SZ - Page 88

88
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
ŶƈƑƖƒƕŃŝŃŵƈƏƒƄƇ
●
Call page 3/3 from the [Sensor] menu.
This page is set when using multiple telemetry sensors of the
same type.
When using multiple sensors of the same type
the sensors must be registered in the transmitter.
Connect all the sensors to be used to the T26SZ as
VKRZQLQWKH¿JXUHDWWKHULJKWDQGUHJLVWHUWKHPE\
the following procedure. The ID of each sensor is
registered in the transmitter.
Hub
Hub Hub
SENSOR SENSOR SENSOR SENSOR SENSOR
ŵƈƄƇƌƑƊŃƄƏƏŃƗƋƈŃƖƈƑƖƒƕƖŃƗƒŃƅƈŃƘƖƈƇ
&RQQHFWWKHVHQVRUWRWKH76=DVVKRZQLQWKHÀJXUHDERYH
2. Tap “Reload” on page 3/3 of the [Sensor] screen.
3. Tap “Reload”.
All the sensors are registered and can be used.
*It is not necessary to carry out
multiple battery connections like
a T18MZ/T14SG.
ŶƈƑƖƒƕŃŝŃŵƈƊƌƖƗƈƕ
This page is set when using multiple telemetry sensors of
the same type.
This function registers an additional sensor.
Connect the sensor as shown in the figure at the
right and register it by the following procedure.
The sensor ID is registered in the transmitter.
SENSOR
ŤƇƇƌƗƌƒƑƄƏŃƖƈƑƖƒƕŃƕƈƊƌƖƗƕƄƗƌƒƑ
&RQQHFWWKHVHQVRUWRWKH76=DVVKRZQLQWKHÀJXUHDERYH
2. Tap “Register” on page 3/3 of the <Sensor> screen.
3. The sensor is registered and can be used.
*When the number of slots needed in registration is insufficient, an error is
displayed and registration cannot be
performed. Disable unused slots or
perform the following reload.
●
Call page 3/3 from the [Sensor] menu.
●
Return to Linkage
menu
●
Return to Linkage
menu