FUTABA T26SZ - Page 89

89
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
*For some transmitters (e.g., T6K), when the start slot of a
sensor is changed, the sensor cannot be used.
WARNING
This procedure changes the slot number of one
registered sensor.
ŶƈƑƖƒƕŃƖƏƒƗŃƆƋƄƑƊƈ
1. Connect the sensor to the T26SZ as shown in the
ÀJXUHDERYH
2. Tap “Change slot” on page 3/3 of the <Sensor>
screen.
3. Tap “Read”.
4. A sensor details screen appears.
5. The current start slot is displayed. To change a
start slot, a
＋
Ɇ

button, tap.
（
Cannot be set to a
slot that cannot be allocated like the table of all
pages.
）
6. Tap to the “Write”.
ŶƈƑƖƒƕŃŝŃŦƋƄƑƊƈŃƖƏƒƗ
ŷƋƌƖŃƓƄƊƈŃƌƖŃƖƈƗŃƚƋƈƑŃƘƖƌƑƊŃƐƘƏƗƌƓƏƈŃƗƈƏƈƐƈƗƕƜŃ
ƖƈƑƖƒƕƖŃƒƉŃƗƋƈŃƖƄƐƈŃƗƜƓƈő
SENSOR
●
Call page 3/3 from the [Sensor] menu.
●
Tap the [Change slot] button in
the Sensor screen to call the setup
screen shown below.
●
Return to Linkage
menu
Donotdisconnectorturntransmitter
powerOFFwhiletelemetrysensordata
isbeingsaved.
Sensorsavedatawillbelost,resultingin
malfunction.