FUTABA T26SZ - Page 90

90
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
ŧƌƖƓƏƄƜŃŶƈƑƖƒƕƖ
Default display sensors can only be used by connecting the
sensors to the receiver. For display of other sensors or to use the
same type of sensor in multiple cases, either register them via
the "Sensor" option on the Linkage menu or allocate the sensors
to empty slots to have them display on the Telemetry screen.
Refer to the previous "Sensor" explanation pages for how to do
this.
Varioustelemetrydata
Choosethedesiredsensorandtap.
Startslotnumber
ŷƈƏƈƐƈƗƕƜŃ
Displaying data from the receiver
This screen displays your choice of data from the
receiver.
Also warnings can be activated regarding the data.
For example, if the receiver voltage drops, the user
can be warned by an alarm (and vibration).
●
Tap the [Telemetry] button in the Linkage menu to call
the setup screen shown below.
Tappagebuttonto
advancetonextpage.
(Thenumberofpages
changeswiththenumber
ofsensorregistration.)
Max.andmin.values
sincethepowerwas
turnedONwilldisplay.
●
Return to Linkage
menu