FUTABA T26SZ - Page 91

91
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
ŷƈƏƈƐƈƗƕƜŝŃŵƈƆƈƌƙƈƕŃžťƄƗƗƈƕƜƀ
Displaying data from the receiver
battery voltage
In this screen, the battery voltage of a receiver is
displayed.
If it becomes higher or lower than the settin, an
alarm and/or vibration will alert you.
ŤƏƄƕƐŃƖƈƗŃ
1. Tap Alarm and choose from Buzzer, Voice, and
Inhibit.
2. Choose "Inhibit" for Vibrator if not using the vibrator
alarm. If using vibrator, choose one of the three
types.
3. Tap to the Limit [4.0 V] item.
4. Adjust the rate using the
"▼▼""▼""▲""▲▲"
buttons.
Initial value: 4.0 V
 $GMXVWPHQWUDQJH9a9
*When the screen is tapped for one second, the rate is reset
to the initial value.
5. To terminate the input and return to the original
state, push the EXIT button.
Receiverbattery
voltage
Setsthevoltageon
whichthealarm
operates.
↓ The"down"arrowwill
indicatethatanalarm
willsoundwhenthe
voltagedropstobelow
thesetting.
Alarmischosenfrom
Buzzer,Voice,and
Inhibit.
AllowsSpeechtobe
turnedONorOFF.
●
Tap the [Receiver] button in the Telemetry screen to call
the setup screen shown below.
Max.andmin.values
sincethepowerwas
turnedONwilldisplay.
Type1
Type2
Type3
"Vibrator"type
Ifthefollowingtypesareselected,thetransmitter
willvibrateduringthewarning.
●
Return to Linkage
menu