FUTABA T26SZ - Page 92

92
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
ŷƈƏƈƐƈƗƕƜŝŃŵƈƆƈƌƙƈƕŃžŨƛƗőŃƅƄƗƗƈƕƜƀ
ŤƏƄƕƐŃƖƈƗŃ
1. Tap Alarm and choose from Buzzer, Voice, and
Inhibit.
2. Choose "Inhibit" for Vibrator if not using the vibrator
alarm. If using vibrator, choose one of the three
types.
3. Tap to the Limit [4.0 V] item.
4. Adjust the rate using the
"▼▼""▼""▲""▲▲"
buttons.
Initial value: 4.0 V
 $GMXVWPHQWUDQJH9a9
*When the screen is tapped for one second, the rate is reset
to the initial value.
5. To terminate the input and return to the original
state, push the EXIT button.
Ext.battery
voltage
Setsthevoltageon
whichthealarm
operates.
↓ The"down"arrowwill
indicatethatanalarm
willsoundwhenthe
voltagedropstobelow
thesetting.
Alarmischosenfrom
Buzzer,Voice,and
Inhibit.
AllowsSpeechtobe
turnedONorOFF.
●
Tap the [Receiver] button in the Telemetry screen to call
the setup screen shown below.
Max.andmin.values
sincethepowerwas
turnedONwilldisplay.
Type1
Type2
Type3
"Vibrator"type
Ifthefollowingtypesareselected,thetransmitter
willvibrateduringthewarning.
Displaying data from the EXT
battery voltage port
The EXT-VOLT screen will display the data from
the EXT-battery output from the R7208SB or
R7308SB receiver.
In order to use this function, it
is necessary to connect external voltage connector
of the R7208SB or R7308SB receiver to a CA-
RVIN-700 or SBS-01V to the battery you desire to
measure the voltage of
the EXT-battery.
You will be alerted by an alarm or vibration if the
voltage set by you is exceeded.
*CA-RVIN-700mustbeinstalledintheaircraft.
●
Return to Linkage
menu