FUTABA T26SZ - Page 93

93
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
Temperature
Setsthetemperature
onwhichthealarm
operates.
↑Anupwardarrow
willshowthatanalarm
willsoundwhenthe
temperaturerisesabove
thesetvalue.
↓Adownwardarrow
willshowthatanalarm
willsoundwhenthe
temperaturedrops
belowthesetvalue.
Alarmischosenfrom
Buzzer,Voice,and
Inhibit.
AllowsSpeechtobe
turnedONorOFF.
●
Tap the [Temperature] button in the Telemetry screen to
call the setup screen shown below.
Max.andmin.values
sincethepowerwas
turnedONwilldisplay.
ŷƈƏƈƐƈƗƕƜŃŝŃŷƈƐƓƈƕƄƗƘƕƈ
Displaying data from the temperature
Temperature is a screen which displays/sets up
the temperature information from an optional
temperature sensor.
The temperature of the model (engine, motor,
EDWWHU\HWFZKLFKLVÀ\LQJFDQEHGLVSOD\HG
If it becomes higher or lower than the setting, an
alarm and/or vibration will alert you.
ŤƏƈƕƗŃƖƈƗŃŝŃŷƈƐƓƈƕƄƗƘƕƈŃƚƄƕƑƌƑƊŃ
1. Tap Alarm and choose from Buzzer, Voice, and
Inhibit.
2. Choose "Inhibit" for Vibrator if not using the vibrator
alarm. If using vibrator, choose one of the three
types.
3. Tap to the Limit [
℃
] item.
4. Adjust the rate using the
"▼▼""▼""▲""▲▲"
buttons.
 ,QLWLDOYDOXHŃ
℃
Ņ
℃
Adjustment range: -20
℃
a
℃
Ń/LPLW
≧
Ņ/LPLW
*When the screen is tapped for one second, the rate is reset
to the initial value.
5. To terminate the input and return to the original
state, push the EXIT button.
*Atemperaturesensormustbeinstalledintheaircraft.
Type1
Type2
Type3
"Vibrator"type
Ifthefollowingtypesareselected,thetransmitter
willvibrateduringthewarning.
●
Return to Linkage
menu