FUTABA T26SZ - Page 94

94
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
rpm
Setstherpmonwhich
thealarmoperates.
↑Anupwardarrowwill
showthatanalarmwill
soundwhentherpm
risesabovethesetvalue.
↓Adownwardarrow
willshowthatanalarm
willsoundwhentherpm
fallsbelowthesetvalue.
Alarmischosenfrom
Buzzer,Voice,and
Inhibit.
AllowsSpeechtobe
turnedONorOFF.
●
Tap the [ rpm sensor] button in the Telemetry screen to
call the setup screen shown below.
Max.valuessincethe
powerwasturnedON
willdisplay.
Type1
Type2
Type3
"Vibrator"type
Ifthefollowingtypesareselected,thetransmitter
willvibrateduringthewarning.
ŷƈƏƈƐƈƗƕƜŃŝŃŵųŰŃŶƈƑƖƒƕ
Displaying data from the rpm
The RPM Sensor screen is used to set up an
optional rpm sensor and display the rotation
information it transmits.
The rotation of the model (engine, motor, etc.)
ZKLFKLVÀ\LQJFDQEHVKRZQ
If it becomes higher or lower than the setting, an
alarm and/or vibration will alert you.
ŤƏƄƕƐŃƖƈƗŃŝŃŲƙƈƕŃ
(
ŸƑƇƈƕ
)
ŃƕƒƗƄƗƌƒƑƖŃ
1. Tap Alarm and choose from Buzzer, Voice, and
Inhibit.
2. Choose "Inhibit" for Vibrator if not using the vibrator
alarm. If using vibrator, choose one of the three
types.
3. Tap to the Limit [
xxx
rpm] item.
4. Adjust the rate using the
"▼▼""▼""▲""▲▲"
buttons.
 ,QLWLDOYDOXHŃUSPŅUSP
 $GMXVWPHQWUDQJHUSPaUSP
Ń/LPLW
≧
Ņ/LPLW
*When the screen is tapped for one second, the rate is reset
to the initial value.
5. To terminate the input and return to the original
state, push the EXIT button.
*Anrpmsensormustbeinstalledintheaircraft.
"Magnet"
"Optics"
"Brushlessmotor"
SBS-01RM→
SBS-01RO →
SBS-01RB→
Gearratio
Blade
Pole
1.00~99.00
2~10
2~30
●
Return to Linkage
menu