FUTABA T6K - Page 39

Beforeuse
39
ŵŖœœřŶť

ŦūŃŰŲŧŨ




⇔

   
allocations as described in the table below.
1 Turn on the receiver. (At this moment, the
transmitter should be off.) Then, LED blinks
RED in about 3 seconds. Next, wait until it
becomes solid RED.
2 Press and hold the Mode switch more than 5
seconds.
3 Release the button when the LED blinks RED
and GREEN simultaneously.
4 The receiver is now in the "Operation CH Set"
mode. At this moment, the LED indicates

that corresponds to the CH mode.
ModeA ModeB
6/SB 6CH S.BUS
RedLEDblink 1time 2time

Default CH mode
*Cannot exit this CH setting mode before the operation mode is




5 By pressing the Mode switch, the operation
CH is switched sequentially as " Mode A"
"Mode B" "Mode A"....
6 The operation mode will be set by pressing
the Mode switch more than 2 seconds at the
desired CH mode.
7 Release the button when the LED blinks
RED and GREEN simultaneously. Then, the

6 After confirming the operation CH mode is
changed, turn off and back on the receiver
power.
     
receiver communicates to the transmitter.
PWM6ch
S.BUS
WARNING

Don't connect servo for
conventional system to S.BUS
port.



