FUTABA T6K - Typical Installation

Beforeuse
38
DANGER
Don't connect a connector, as shown in a
before figure.



Don't connect servo for conventional system
to S.BUS2 port.


WARNING

Don't connect an S.BUS servo / gyro to
S.BUS2 connector.
ŵŨŦŨŬŹŨŵŃűŲŰŨűŦůŤŷŸŵŨ

6%86SRUW
6%%ك
56%
+8%
+8%
7HOHPHWU\6HQVRU
7HOHPHWU\6HQVRU
7HOHPHWU\6HQVRU
%DWWHU\
6ZLWFK
0RGHVZLWFK
$QWHQQD
/('
؟$LOHURQVHUYR
؟(OHYDWRUVHUYR
؟7KURWWOHVHUYRHQJLQH
؟5XGGHUVHUYR
؟*\URJDLQق+HOLFRSWHUك
؟*HDUVHUYRDLUSODQH
؟3LWFKVHUYRق+HOLFRSWHUك
؟)ODSVHUYRDLUSODQH
؟0RWRUFRQWUROOHUHOHFWULF
(Typical installation)
LED Indication
Green Red Status
Off Solid No signal reception
Solid Off Receiving signals
Alternate blink Unrecoverable error (EEPROM, etc.)
5HFHLYHU
DANGER
Do not insert either a switch
or battery in this manner.

Use the small plastic screw
driver that was included with your
receiver.
Switch is also used for the CH

⇔
