To prevent the servo lead cable from being
little slack in the cable and fasten it at suitable
maintenance.
Fasten about 5-10cm
from the servo outlet so
that the lead wire is neat.
Margin in the lead wire.
ŰŲŸűŷŬűŪŃŷūŨŃųŲźŨŵŃ
ŶźŬŷŦūŃ
make a rectangular hole that is a little larger than
the total stroke of the switch so that you can turn
Avoid mounting the switch where it can be
recommended to mount the power switch on the
ŶŤũŨŷżŃųŵŨŦŤŸŷŬŲűŶŃ
ƚƋƈƑŃƜƒƘŃƌƑƖƗƄƏƏŃƕƈƆƈƌƙƈƕŃ
ƄƑƇŃƖƈƕƙƒƖ
WARNING
Be sure to insert the connector until it stops
at the deepest point.
Wrap the receiver with something soft such
as foam rubber to avoid vibration. If there is
a chance of getting wet, put the receiver in
a waterproof bag or balloon to avoid water.
Never cut the receiver's antenna. Do not
bind the receiver's antenna with the cables
for servos.
Locate the receiver's antenna as far as
possible from metals or carbon fiber
components such as frames, cables, etc.
*Cutting or binding the receiver's antenna will
and may cause a crash.
Adjust your system so that pushrods will not
bind or sag when operating the servos to
the full extent.
on the gear train and/or power consumption
causing rapid battery drain.
Use a vibration-proof rubber (such as
rubber grommet) under a servo when
mounting the servo on a servo mount. And
be sure that the servo cases do not touch
directly to the metal parts such as servo
mount.
vibration will travel to and possibly damage the
servo.
ŰŲŸűŷŬűŪŃŷūŨŃŶŨŵŹŲŃ
To Next Page
Loading...
