FUTABA T6K - Page 46

Beforeuse
46
ŶőťŸŶŒŶőťŸŶŕŃŧŨŹŬŦŨŃŶŨŷŷŬűŪ

setting and other data can be entered for the S.BUS/S.BUS2 servos or sensors.
3-way hub
or Y-harnesses
6%866%86
6HUYR
6%866%86
GHYLFH
7HOHPHWU\VHQVRU
5HFHLYHUV
%DWWHU\
%DFNRI7.
1. Turn on the transmitter power.
2. Call the setup screen.
Servo:
→
S.BUS
3. Connect the S.BUS device and battery you
want to set with a 3-way hub or Y-harnesses

4. Perform setting in accordance with each
screen.
5. This sets the channel and other data for each
S.BUS servo, or telemetry device to be used
with the S.BUS device or receiver.