FUTABA T6K - Page 50

50
Commonfunction
Function
Method
①Callthemenuscreenfromthe
homescreenbypressingthe+key
for1second.
＋
② Select
fromthemenuwiththeJog
key.
③Openthesettingscreenby
pressingtheJogkey.
（1second）
Callingthesettingscreen
Modelselect（SELE）
Themodeldataofupto30modelscanbestoredinthetransmitter.Thisfunctionisusedwhen
callingsavedmodeldata.
Receiverselection（RX）
TheR3006SBsuppliedwiththetransmitter,employstheT-FHSSAirsystem.Whenyouwanttouse
anS-FHSSreceiver,switchtoS-FHSShere.However,thetelemetryfunctioncannotbeusedwiththe
S-FHSSsystem.
Link（LINK）
Whenlinkingwiththereceiver,thetransmitterissettothelinkmodehere.TheIDnumberofthe
currentlylinkedreceiverisdisplayed.
Datareset（RES）
Themodeldatacurrentlyinusecanberesettoitsinitialvalue.However,itdoesnotResetother
thanthefollowingofaparameter.
[Thefunctionresetinaparameter:TELEMETRYmode,STKPOSIALRM]
Modelcopy（COPY）
Thisisthemodeldatacopyfunction.Itisconvenientwhenyouwanttostoremodeldataasbackup
orbuildanumberofmodelswiththesamedatasettings.
● Thedataofthemodelmemorycurrentlyinusecanbecopiedtoanothermodelmemory.
"MDLSEL"
MDLSEL
Modelselect（Select ／ RXtype ／ Link ／ Reset ／ Copy）
(Common)
Modelselect
RXsystem
Link
Reset
（Modelnumber：1 〜 30）
● Originaldata:Modeltype
Modelname
● System（T-FHSSAirorS-FHSS)
●LinkreceiverID
Iftelemetryisused,thereceiver
IDisneeded.
● Selectthesetting
itemwiththeJog
key.
This function is used when calling and copying
model data stored in the transmitter. The selected
model data can also be reset. System changes
(T-FHSS Air, S-FHSS) matched to the receiver type
and linking with the receiver are also done here.