FUTABA T6K - Page 60

60
Commonfunction
Function
Method
①Callthemenuscreenfromthe
homescreenbypressingthe+key
for1second.
＋
② Select
fromthemenuwiththeJog
key.
③Openthesettingscreenby
pressingtheJogkey.
（1second）
Callingthesettingscreen
① SelectthetrimyouwanttosetfromtheSTEPitem
andsetthestepsizebypressingthe+keyor‒key.
＋ −
or
Range：1〜40
Default：4
● Whenyouwanttoreturnthe
setvaluetotheinitialvalue,
pressthe+keyand‒key
simultaneously.
① SelectthetrimyouwanttosetfromtheTYPEitem
andsetthetrimtypebypressingthe+keyor‒
key.
＋ −
or
Range：NOR,CNT,ATL
(THR)
Trimstep
Trimtype
TrimType
The amount of trim change trim type can be
changed between NOR (normal), ATL and CNT
(center) according to the trim application.
TrimStep
The amount of trim change per step can be
changed between 1 and 40 according to the aircraft
capacity and trim application.
Set it to match the application. With ordinary
● Forexample,whenthestepsizeistheinitialvalue(4),trimmovementfrom
centertoendis30steps.Ifthestepsizeismade40,thetrimmoves3steps.
"TRIM"
Trimstep
● Selecttheitemwiththe
Jogkey.
（Trimsteprate）
TRIM
Trimreset ／ Trimstep
(Common)
TRIM(BesidesTHR)NOR ⇔ CNT
CNT:Withthecentertrimfeature,
trimadjustmentshaveno
effectonthemaximumservo
travel.Thispreventsthe
linkagesfrombindingwhen
adjustmentsaremade.
THRTRIMATL ⇔ NOR
ATL:WiththeATLtrimfeature,
trimadjustmentshave
noeffectonthehigh
throttle.Thispreventsthe
linkagesfrombindingwhen
adjustmentsaremade.
aircraft, a setting of about 2 to 10 should be fine.
