FUTABA T6K - Page 70

70
Commonfunction
（Changingthemixingreferencepoint）
（Includingtrimoperation）
■ Mixingreferencepointsetting
（1second）
① Selectthe"OFFST"itemandhold
themastersidestickorknobin
thepositionyouwanttosetand
setthenewreferencepointby
pressingtheJogkey.
Range：-100 〜 +100%
（THRonly0 〜 100%）
Default：0%
■ TrimON/OFFsetting
＋ −
or
①Selectthe"TRM"item
andselectONorOFFby
pressingthe+keyor‒key.
Range：OFF、ON
Default：OFF
● Whenyoudonotwanttoincludetrimin
mixingselectOFF.

At the end of setting, check that the mixing function is performed normally.
（P.MIX4setupscreen）
● Selecttheitemwiththe
Jogkey.
5Pointcurve
setting
● Thesetcurveisdisplayedona
graph.
Functionactivation
MasterCHselect
SlaveCHselect
Switchselection
SwitchONdirection
● WhenINHisselected,the
functioncannotbeused.
WhenON orOFFisselected,
thefunctionisactivated.ON
andOFFchangesarelinked
totheswitch.
RefertotheP.MIX1 〜 3settingmethoddescribedpreviouslyforsettingsotherthanthe5pointcurvesetting
describedbelow.
■ 5pointcurvesetting
＋ −
or
① Selectthesettingitem(P-1 〜 P-5)ofeachpointwiththeJogkeyandsettheamountof
movementofeachpointbypressingthe+keyor‒key.
Range：-100 〜 +100%
Default：0%

At the end of setting, check that the mixing function is performed normally.
P.MIX4
CAUTION
CAUTION