FUTABA T8J-2.4G - Throttle Delay Function (THR-DELAY) (ACRO); THR-DELAY for Simulating Turbine Lag

63
Throttle delay function
THR-DELAY
(
ACRO
):
The
THR-DELAY
function is used to slow the response of the throttle servo to
simulate the slow response of a turbine engine. A
40%
delay setting corresponds
WRDERXW D RQHVHFRQGGHOD\ ZKLOH D
100%
GHOD\ WDNHV DERXWHLJKW VHFRQGVWR
UHVSRQG)RUKHOLFRSWHUVVHH
DELAYS
, p. 84.
7KLVIXQFWLRQ PD\DOVR EHXVHG WRFUHDWH D³VORZHG VHUYR´ RQ D FKDQQHO RWKHU WKDQ WKURWWOH7KLV LV DFFRPSOLVKHG E\
SOXJJLQJWKHGHVLUHGVHUYR([JHDUGRRUVLQWR&+
THR
), throttle into an auxiliary channel such as 8, and then using
VRPHFUHDWLYHPL[HV3OHDVHVHHRXU)UHTXHQWO\$VNHG4XHVWLRQVDUHDDWZZZIXWDEDUFFRP?IDT?IRUWKLVVSHFL¿FH[DPSOH
GOAL of EXAMPLE: STEPS: INPUTS:
Activate
THR-DELAY
IRUDGXFWHGIDQ
UHSOLFDRIDWXUELQHSRZHUHGDLUFUDIW
Slow the servo response by one second.
Open the
THR-DELAY
function.
for 1 second.
to
THR-DELAY
.
Activate the function.
to
MIX
. to
ACT
.
Adjust the
RATE
to match the desired
servo speed. (Ex:
40%
.)
to
RATE
. to
40%
.
Close menu.
Where next? Set up
THROTTLE-NEEDLE
mixing: see p. 62.
$GMXVWWKURWWOH¶V
END POINT
: see p. 36.
Adjust throttle exponential (
D/R
,
EXP
): see p. 39.
Set up
AILEVATOR
: see p. 54.
Set up programmable mixes, for example,
RUDDER-AILERON
: see p. 65.
9LHZDGGLWLRQDOPRGHOVHWXSVRQWKHLQWHUQHWZZZIXWDEDUFFRP?IDT?
Where next? Set up
THROTTLE DELAY
WRLPLWDWHDMHWHQJLQH¶VODJVHHS
Adjust throttle and Ch8
END POINTs
: see p. 36.
Set up programmable mixes, for example,
AILERON-to-RUDDER
: see p. 65.
9LHZDGGLWLRQDOPRGHOVHWXSVRQWKHZZZIXWDEDUFFRP?IDT?