FUTABA T8J-2.4G - Linear Programmable Mixes (PROG.MIX1-4); Understanding Linear Programmable Mixes

65
LINEAR PROGRAMMABLE MIXES (
PROG.MIX1-4
):
6DPSOHUHDVRQVWRXVHOLQHDUSURJUDPPDEOHPL[HV
7RFRUUHFWEDGWHQGHQFLHVRIWKHDLUFUDIWVXFKDVUROOLQJLQUHVSRQVHWRUXGGHULQSXW
7RRSHUDWHRUPRUHVHUYRVIRUDVLQJOHD[LVVXFKDVWZRUXGGHUVHUYRV
7RDXWRPDWLFDOO\FRUUHFWIRUDSDUWLFXODUDFWLRQVXFKDVORZHULQJHOHYDWRUZKHQÀDSVDUHORZHUHG
7RRSHUDWHDVHFRQGFKDQQHOLQUHVSRQVHWRPRYHPHQWLQD¿UVWFKDQQHOVXFKDVLQFUHDVLQJWKHDPRXQWRIVPRNHRLOLQ
UHVSRQVHWRPRUHWKURWWOHDSSOLFDWLRQEXWRQO\ZKHQWKHVPRNHVZLWFKLVDFWLYH
7RWXUQRIIUHVSRQVHRIDSULPDU\FRQWUROLQFHUWDLQFLUFXPVWDQFHVVXFKDVVLPXODWLQJRQHHQJLQHÀDPLQJRXWRQDWZLQ
RUWKURWWOHDVVLVWHGUXGGHUWXUQVDOVRZLWKDWZLQ
Adjustability:
'HIDXOWV7KHSURJUDPPDEOHPL[HVGHIDXOWWRWKHPRVWIUHTXHQWO\XVHGPL[HVIRUVLPSOLFLW\,I\RXZDQWWRXVHRQHRI
these mixes, simply select that mix number so that the master and slave servos are already selected for you.

PROG.MIX1
DLOHURQWRUXGGHUIRUFRRUGLQDWHGWXUQV

PROG.MIX2
HOHYDWRUWRÀDSIRUWLJKWHUORRSV
HELI
PL[HVGHIDXOWWRHOHYWRSLWFK

PROG.MIX3
ÀDSWRHOHYDWRUWRFRPSHQVDWHSLWFKLQJZLWKÀDSV
HELI
PL[HVGHIDXOWWRSLWFKWRHOHY

PROG.MIX4
WKURWWOHWRUXGGHUJURXQGKDQGOLQJFRPSHQVDWLRQ
&KDQQHOVDYDLODEOHWRPL[$OOIRXUPL[HVPD\XVHDQ\FRPELQDWLRQRI&+2IIVHWDQGGLDOLQFOXGH'7'7PD\
also be set to the master channels. (see below.)
0DVWHUthe controlling channel. The channel whose movement is followed by the slave channel.
Another channel: 0RVWPL[HVIROORZDFRQWUROFKDQQHO([UXGGHUWRDLOHURQVQRVZLWFKFRUUHFWVUROO
coupling.)
MASTER 6/$9( TRIM 6:,7&+ POSITION RATE 2))6(7
RUDD AIL OFF
ANY
NULL 25% 0
2IIVHWDVPDVWHUTo create an
OFFSET
PL[VHWWKHPDVWHUDV2)6([PRYHÀDSHURQVDVÀDSVRIWKHLUWRWDOWKURZ
when SWITCH C is in down position.)
MASTER 6/$9( TRIM 6:,7&+ POSITION RATE 2))6(7
OFS FLP
N/A
C DOWN 20%
N/A

'LDODVPDVWHU7
RGLUHFWO\DIIHFWRQHVHUYR¶VSRVLWLRQE\PRYLQJDGLDOVHWWKHPDVWHUDVWKHGHVLUHGGLDO
(Ex: create a second throttle trim on DT6 lever.)
MASTER 6/$9( TRIM 6:,7&+ POSITION RATE 2))6(7
DT6 THR
N/A ANY
NULL 5%
N/A
6ODYH the controlled channel. The channel that is moved automatically in response to the movement of the master
FKDQQHO7KHVHFRQGFKDQQHOLQDPL[¶VQDPHLHDLOHURQWRUXGGHU
7ULPPDVWHU¶VWULPDIIHFWVVODYH1RWGLVSOD\HGLIPDVWHULVQRW&+EHFDXVHKDYHQRWULP([WZRUXGGHUVHUYRV
With
TRIM OFF
, rudder trim would bind the two servos.
TRIM ON
resolves this.
Your 8J contains four separate linear programmable mixes. (Note that P.Mixing
PL[LQJUDWHVDUHVHWZLWKDSRLQWFXUYH6HH&859(0,;(6
There are a variety of reasons you might want to use these mixes. A few are
OLVWHGKHUH$OORIWKHDGMXVWDEOHSDUDPHWHUVDUHOLVWHGEHORZEXWGRQ¶WOHWWKHP
VFDUH\RX)RU\RXU¿UVWIHZWLPHVH[SHULPHQWLQJZLWKPL[HVMXVWWXUQRQWKH
GHIDXOWPL[HV DGMXVW WKHPKRZ \RX WKLQNWKH\ QHHG WR EH WKHQ XVH WKH VHUYR
VFUHHQWR FKHFNDQG VHHLI \RXZHUH FRUUHFW$VZLWK DOOIXQFWLRQV DVDPSOH
setup follows, step by step, to assist you.