00075751.DOC, Version 1.1 46/54
Control Board
The Control Board offers several features: you can simply set the starting address, run the pre-programmed
program or make a reset.
The main menu is accessed by pressing Enter until the display is lit. Browse through the menu by pressing
the arrow buttons (up, down, left, right). Press Enter in order to select the desired menu. You can change the
selection by pressing the arrow buttons. Press Enter in order to confirm. The functions provided are
described in the following sections.
Default settings shaded. Basic Reload / Program Reload / Private Reload
Main menu Sub menu Display Function
Connect
DMX Address
DMX address
setting
Wireless Wireless DMX
Light
Max Temperature
80-139°C,90°C/176-282°F,194°F
LED off at
temperature
Lamp Adjust
PAN ... Service function
Information
Time info
Current XXXX (h)
Power on running
time
Fixture Life XXXX (h) Fixture running time
Temperature Near Lamp Temp. ... XXX °C/°F Inside temperature
Fans Speed Near Lamp Fan Fan speed
Channel Value
PAN ... PAN = XXX ... Initial effect position
Error Message PAN, TILT ... Error channels
Fixture Model xxxxxxxxxxxx
Model number and
brand
Software Ver
1U01 V 1.0.00
2U01 V 1.0.00 ...
Software version of
each IC
Set
Reset
All
Reset all motors
PAN&TILT
Reset only
PAN/TILT
Others
Reset other motors
Movement
PAN reverse
ON/OFF
Reverse movement
TILT reverse ON/OFF
PAN degree 630/540
Select PAN-angle
630° or 540°
Encoders ON/OFF
Automatic PAN/TILT
calibration
PAN/TILT Mode Stand/Smooth
Adjust PAN/TILT
speed
UI Set
Mic Sens
0~99%, 60%
Mic sensitivity
No Signal
Close/Hold/Auto/Music Run if no DMX
Temperature C/F Celsius/Fahrenheit
Select temperature
designation °C or °F
Fans Mode Auto Speed/High Speed
Fans mode select
Hibernation OFF, 01M-99M, 15M
Standby mode
Backlight 02M-60M, 02M Display shutoff time
Flip Display ON/OFF
Display reverse 180
degree
Display Bright 00-31 10 Display Brightness
Brand Show ON/OFF Show brand name
Key Lock ON/OFF Key lock activation
To Next Page
Loading...
