FUXTEC FX-WP152 - Cold Start of the Device

To Next Page

To Previous Page

Original User Manual FUXTEC FX-WP series_en

7. Cold start of the Engine

1. Place the device on a firm and flat surface.

Press the Start/Stop switch.

2. Move the choke lever upwards to "COLD START."

3. Press the carburettor pump about 8-10 times (until gasoline flows in the line)

4. Pull out the starter rope with a short-stroke until resistance is felt

(about 100mm). A continuous, high-speed train will provide a vital spark and start the

engine

5. Then set the choke lever to the "WARM START" position

6. Let the engine warm-up for about 10 minutes at idle

NOTE: If the device does not start after repeated attempts, refer to troubleshooting

chapters.

NOTE: Always pull the starter cord straight out. Pulling the starter at an angle will cause

the rope to rub against the eyelet. Pulling the starter at an angle can cause the starter