Original User Manual FUXTEC FX-WP series_en
12
Gasoline is highly flammable and can cause an explosion in case of sparks
Refuel only in well-ventilated rooms and let the engine cool down before filling.
Smoking and open fire, as well as any sparks, must be avoided during refuelling
Do not overfill the tank (see figure max. filling level)
After refuelling, check that the fuel filler cap is properly closed
Avoid any spillage of gasoline
Keep the device away from children
Gasoline with an ethanol content
The engine can be operated with E10 gasoline. However, do not use gasoline with
a higher ethanol content than 10%.
6. Pre-pumping the Engine
Before starting the engine, remove the filler cap from the pump chamber and
fill it with water. Reset the filling cap and pull
tight.
NOTE
Dry operation of the pump will cause damage to the pump seals. If the pump runs dry,
switch off the engine immediately and let the pump cool down before pre-pumping.
To Next Page
Loading...