Original User Manual FUXTEC FX-WP series_en
14
cord to fray or break. Always hold the starter handle firmly when the rope pulls back.
Never let the rope be thrown back from the pulled-out position. That could damage the
starter device.
Adjusting the pump capacity
After the engine has been started, the pumping capacity
can be adjusted via the throttle lever. Move the throttle
lever towards the device to increase the flow rate, move
it forward towards the pipe to decrease it.
8. Warm start of the engine
1. Place the device on a firm and flat surface.
2. Move the engine stop switch down
3. Slide the choke to the "WARM START" position
4. Pull out the starter rope with a short-stroke until resistance is felt
(about 100mm). A continuous, high-speed train will provide a vital spark and start the
engine
If the device does not start, please proceed again according to "Cold start of the device
9. Stopping the device
Slide the throttle stick to the LOW position. Let the device return to idle. Push the engine
stop switch to the OFF position upwards until the device stops. If it does not control, pull
out the spark plug connector in an emergency. Never leave the device unattended while
it is running.
HIGH
LOW
To Next Page
Loading...