FUXTEC FX-WP152 - Storage of the Device

Original User Manual FUXTEC FX-WP series_en
17
11. Storage of the device
WARNING: Failure to follow these steps may result in carburettor fouling.
That makes later starting difficult and causes permanent damage
1. Perform all general maintenance recommended in the maintenance section of
your user manual.
2. Clean the device's exterior, drive axle, protective shield, and nylon cutting head.
3. Drain fuel from the fuel tank.
4. After fuel is drained, start the device.
5. Let the device idle until the device stops by itself. That will clean the carburettor of
fuel.
6. Let the device cool down (about 5 minutes).
7. Use a spark plug wrench, remove the spark plug.
8. Pour 1 teaspoon of clean 2-stroke oil into the combustion chamber. Pull the starter
rope
slowly several times to coat the internal components. Replace the spark plug.
9. Store the device in a cool, dry place away from any ignition source such as an oil
burner, water heater, etc.
TRANSPORT PROTECTION
Make sure that the device is well-secured during transport to avoid fuel loss, damage, or
injury. Install transport protection for metal sheets during transport and storage