6
Working mode switches
The LMS-1 posses two working modes set by DS1 switch
- DS1=OFF, one input/four outputs, Y IN/ABCD OUT, this working mode
enables for example to choose the amp to which the guitar will be plugged in
- DS1=ON, four inputs/one output, ABCD IN/Y OUT, this working mode
enables to choose signal source (e.g. guitar) connected to the amp.
In working mode one input/four outputs the DS2 switch decides about working mode of
the switches:
- DS2=OFF, „one of four” mode, pressing of chosen switch makes a connection
between input Y and chosen output,
- DS2=ON, „one or more” mode, pressing of chosen switch toggles the state
(correspondingly turning on or off) of chosen output what enables to send the signal to
several devices. It is not recommended to use this mode for guitar with two or more
amps because it creates the ground loop which can (especially on high gain tones)
provoke audible hum in speakers.
To Next Page
Loading...
