EasyManua.ls Logo

G-Prject G-BOOM - POWER AND CHARGING; Power Source Connection; Charging the Unit

G-Prject G-BOOM
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
POWER SOURCE
Connect the supplied AC adaptor (DC 12V 2A) to the DC In jack on the back of
G-BOOM and plug the other end into a standard wall outlet (100~240V 50-60Hz).
NOTES: Disconnect both ends of the power cord when not in use. Use only the supplied
AC adaptor with the following specs: AC In - 100-240V AC, 50/ 60Hz / DC Out - 12V 2A.
GETTING CHARGED UP
For rst time use, charge the unit for about 6 hours.
After the initial charge, it takes up to 3.5 hours to charge.
Fully charged battery can operate for up to 6 hours
(varies by volume level and audio content).
NOTES:
The battery is internal and cannot be replaced
Actual battery life varies with use, settings, and environmental conditions
Rechargeable batteries have a limited number of charge cycles
Charge the rechargeable battery at least biannually
AC outlet
AC adapters plug