G-project G-BUZZ - Clock and Display Settings; Initial Clock Setup; Resetting the Time

INITIAL CLOCK SETUP
1 Using the supplied AC power adapter, plug G-BUZZ into an AC power source
or install four “AAA” batteries.
2 With G-BUZZ in STANDBY mode, the LED display will begin flashing the default
time of “12:00”.
3 Press the << button repeatedly to select the current hour and press the
>> button repeatedly to select the current minute.
4 Press the TIME button to save the new clock setting.
RESETTING THE TIME
1 Make sure G-BUZZ is powered off, in STANDBY mode.
2 Press and hold the TIME button until the display begins to flash.
3 Press the << button repeatedly to select the current hour, then press the
>> button repeatedly to select the current minute.
4 Press the TIME button again to save the new clock setting.