G-Technology G-RAID with Thunderbolt - Configure RAID Mode for Mac

p.21
Using RAID Modes
Congure the RAID Mode for Mac
You can easily congure G-RAID with Thunderbolt’s RAID mode with the following steps.
Important Note: Changing the RAID level will erase all data on the drive. Be sure all of
the data and les you want to save are backed up to separate media.
1. In the G-RAID with Thunderbolt Conguration Utility, click on the Congure button.
A dialog window will pop up with three options for conguring your disk set, as
shown below. The dialog window will also warn you that when you congure your
RAID set, all data on the drive will be erased.
2. Select your desired conguration with the RAID 0 (Performance), RAID 1 (Protected),
or JBOD radio buttons. Then click the Congure button to continue.
3. Two warning windows will appear, both letting you know that the following step will
erase all of your data. Click the buttons to continue.