English
50
Children must not carry out
any cleaning and maintenance
operations without being
monitored.
Before connecting the
appliance to the water mains,
please read and follow the
applicable regulations in force
in your country.
If the power cord is damaged,
it must be replaced by the
manufacturer, its service
centre or by adequately
qualified personnel in order
to avoid any risks.
It is recommended the
installation of a residual
current device (RCD) with a
rated residual current not
exceeding 30 mA.
Connect the appliance to a
drinking water main with
pressure between 0.15 MPA
and 0.8 MPA (1.5 and 8 bar);
see data on the data plate.
In case of filling tube
replacement, use the new set
of tubes supplied with the
appliance. Do not use the old
set anymore.
Access to the internal area is
restricted to persons having
knowledge and practical
experience of the appliance,
in particular as far as safety
and hygiene are concerned.
Never clean the internal area
of the machine with power
supply on or with the plug
connected. In any event do
not use water jets or
detergents.
To Next Page
Loading...
