English
63
Before connecting the
water filter to the machine,
perform a wash cycle until
the water is clear. Then
connect the water filter to
the machine.
$POOFDUUIFESBJODVQ'UPUIFESBJOBHFQJQF#
Should the mains pressure
be higher than 0,5 MPa, a
pressure reducer balanced
for high pressure should be
installed (device in which
any mains pressure
increase does not effect
the output pressure).
In case of filling tube
replacement, use the new
set of tubes supplied with
the appliance. Do not use
the old set anymore.
5.2 Electrical connection
Before proceeding with
electrical connection,make
sure that the voltage rating
corresponds with that
indicated on the CE plate
and on the connection
plate on the power supply
cable. Check to ensure that
the electrical supply line is
able to support the
machine load (see chapter
"Technical features").
$POOFDUUPBOFBSUIJOHTPDLFUXIJDIDPNQMJFTXJUI
DVSSFOUMFHJTMBUJPO
Check that the power
supply cable is efficient and
that it complies with
national and European
safety standards.
The user must undertake
to power the machine
protecting the power line
using a suitable safety
switch (cut-out) that
complies with the
legislation in force in the
country itself.
To Next Page
