Gaggia Rl8180 - Heating up the Machine

45
Heating up the machine
During the initial heat-up process, fresh water ows through the internal circuit to
heat up the machine. This takes a few seconds.
1 Place a bowl under the hot water/steam wand or classic milk frother and the
coffee spout. Make sure the control dial points to the coffee bean icon.
2 Press the on/off button.
3 When the warning light ashes quickly, turn the control dial to the hot water
icon and wait a few seconds.
- The warning light goes out and some water comes out of the hot water/
steam wand or classic milk frother.
4 After a few seconds, when hot water stops coming out of the hot water/steam
wand and the warning light ashes slowly, turn the control dial back to the
coffee bean icon.
- The machine is heating up and the on/off button ashes slowly.
- When the machine has heated up, it performs an automatic rinsing cycle to
clean the internal circuit with fresh water. Water ows from the coffee spout.
- When the on/off button lights up continuously, the machine is ready for the
manual rinsing cycle.
Note: You can stop the automatic rinsing cycle by pressing the espresso button or
the regular coffee button.
Note: The automatic rinsing cycle also takes place 15 minutes after the appliance
switches to standby mode or switches off.
45 ENGLISH
4219-465-05501 MANUAL GAG. BESANA EN KOR.indd 45 12/02/2021 11:18:42