Gaggia Rl8180 - If You Are Unable to Finish the Descaling Procedure

59
If you are unable to nish the descaling procedure
If the machine gets stuck in the descaling procedure, you can press the on/off
button.This allows you to complete the descaling procedure. Follow the steps
below to make sure your machine is ready to brew coffee again.
2 Fill the water tank with fresh tap water up to the MAX indication and slide the
water tank back into the machine.
3 Empty the bowl and place it back onto the drip tray under the hot water/steam
wand.
4 Press the espresso button and brew a cup of espresso. Repeat this twice.
5 Turn the control dial to the hot water icon.
6 Let hot water ow out of the hot water/steam wand until the ‘water tank empty’
light lights up continuously.
Note: If you want to interrupt the water ow, turn the control dial back to the coffee
bean icon. To restart the water ow, turn it back to the hot water icon.
7 Remove the drip tray, rinse it and place it back.
8 Reattach the classic milk frother.
9 Remove the water tank and rinse it.
10 Reinstall the Intenza+ water lter (if present).
11 Fill the water tank with fresh tap water up to the MAX indication and slide the
water tank back into the machine.
12 Press the on/off button to switch off the machine.
- When you switch the machine back on, it is ready for use again.
59 ENGLISH
4219-465-05501 MANUAL GAG. BESANA EN KOR.indd 59 12/02/2021 11:19:01