Galanz GLOMJA17S2B-10 - Step 7: Option B - Adapt the Microwave Blower for Outside Back Exhaust

INSTALLING YOUR MICROWAVE
27
Step 7: Option B - Adapt the microwave blower for outside back exhaust
1 Remove and save the ve screws that hold the blower unit in the microwave.
2 Carefully pull out the blower unit. The wires will extend far enough to let you adjust the blower unit. Do not disconnect
the wires.
3 Cut out the vent holes with tin snips.
WARNING: Do not pull or stretch the blower unit wiring. Make sure that the wires are not pinched.
Blower plate and adapter
screws
Blower motor screw
Back of microwave
Blower unit
Blower plate and adapter screw
Blower unit
Vent hole covers