Galanz GLOMJA17S2B-10 - Step 4: Option C - Attach the Mounting Plate to the Wall

INSTALLING YOUR MICROWAVE
32
Step 4: Option C - Attach the mounting plate to the wall
1 Remove the rear wall template.
2 Remove the mounting plate from the upper foam.
3 Insert the bolt(s) through the front of the mounting plate into the hole(s) that are not going into a stud, and then
reattach the toggle wings ¾" onto each bolt. Hold your mounting plate up to holes in your wall to identify the correct
position.
Note: The top of the mounting plate is indicated with an arrow. The mounting plate’s hooks are on the front.
Note: Depending on
your stud locations,
your installation may
look dierent. You
should insert toggle
bolts into drywall and
wood screws into
studs.
Bolt
Wing
Mounting plate