IMPORTANT SAFETY INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for
help.
This appliance must be grounded. In the event of an electrical short
circuit, grounding reduces risk of electric shock by providing an
escape wire for the electric current. This appliance is equipped with
a cord having a grounding wire with a grounding plug. The plug must
be plugged into an outlet that is properly installed and grounded.
Consult a qualified electrician or serviceman if the grounding
instructions are not completely understood, or if doubt exists as to
whether the appliance is properly grounded, and if it is necessary to
use an extension cord, use only a 3-wire extension cord that has a
3-blade grounding plug and a 3-slot receptacle that will accept the
plug on the appliance. The marked rating of the extension cord shall
be equal to or greater than the electrical rating of the appliance.
SAVE THESE INSTRUCTIONS
—
—
—
—
3-Pronged Plug
Ground Plug
3-Prong Receptacle
GROUNDING INSTRUCTIONS
3
UNPACKING INSTRUCTIONS
Unpacking and Examining Your Oven
Carefully remove oven from carton. SAVE THE CARTON AS IT
MAY MAKE INSTALLATION EASIER.
Remove:
All packing materials from inside the oven cavity; however, DO
NOT REMOVE THE WAVEGUIDE COVER, which is located on the
side in the oven cavity. Check to see that there are Installation
Instructions, Wall Template, Top Cabinet Template, bag of Installation
Hardware, Charcoal Filter and Exhaust Damper Assembly. Read
enclosures and SAVE the Owner’s Instructions.
The feature sticker from the outside of the door, if there is one.
Check the oven for any damage, such as misaligned or bent door,
damaged door seals and sealing surfaces, broken or loose door
hinges and latches and dents inside the cavity or on the door. If
there is any damage, do not operate the oven and contact your
dealer. See Installation Instruction for more details.
To Next Page
Loading...
Need help?
General
