3. Tear off the back protective paper of the
window,
then the sides of adhesive tape as FIG.4 -
1,
and stick it on
the window, Tear three right sides protective paper about 10mm, and fix the window in the
doorframe
as
FIG.4-1.
4. Tear off the adhesive protective paper of the lining and stick it on the door as FIG.4 -
1,
slip the hook on the
doorframe, and fix the doorframe on the door, tighten it with
"+"
- screws.
After
assembled, check
whether
the hook working in normal and whether the hinge (UP) is its position.
5. According to the FIG. 4
-4
shown,
pastę the inner lining inside the
doorframe,
mąkę
surę
it is pasted
smoothly, and should have no air
bubble.
6. Slip the washer in the hinge
shaft,
then
put
the hinge
shaft
in the hinge hole on the bottom of the oven, the
hinge in the rectangle hole on the
left
above, and hooked it with the door hook.
7. Place a
0.15mm
thin paper between the door and the oven, level the door and the oven, then push the door
close
to the oven, and tighten the
two
screws of the hinge (UP) and paint them.
4.3 THE
CONTROL
PANEL AND THE
DOOR
RELEASE
WECHANISM.
Puli
out the power
pług.
Take off the cabinet.
Discharge between one end of the capacitor and the baseboard with a
screwdriver.
To
disassemble
1.
Puli
out the terminal
pług
of the time and power distributor.
2. Take off the screw which fix the control panel with a
"+"
- screwdriver
(FIG.4 - 6)
3. Take off the control panel.
To assemble,
(1) Place the two buckles under the control panel into the two rectangle
holes
under the oven as FIG.4 - 6, then
mąkę
close of the control panel and
the oven with being fixed with a screw.
Pług
in the terminal
pług.
Fig.4-6
4.4 THE
MAGNETRON.
Firstly, do as
1,2,3,
steps at III of this
part.
To
disassemble,
1.
Take off the screw beside the oven lamp (FIG.4 - 8).
2. Take out the four screws which fixed the magnetron, and take the magnetron off (FIG.4 - 7).
magnetron
screwe
thermal
cutout
magnetron holder
magnetron
holder
lamp shade
Fig.
4-7
To assemble the magnetron,
1. Check whether the copper filament weaved washer of the magnetron antenna has been placed
well.
It
should not be fixed if there is no copper filament weaved washer, for it
may
cause the magnetron and the
oven can't
earth
well, and cause
large
amount of microwave leakage. Attention : When a new oven matches
11
To Next Page
Loading...
