take the diodę
off.
To assemble,
1.
Insert
one end of the diodę to one feet of the capacitor's connect piece.
2. Fix the diodę with one screw (pay attention to the polarity of the diodę, refer to FIG.4
-16).
4.9 THE TURNTABLE
COMBINATIOM.
Firstly,
do as the
1,2,3,
stops of III of
this
part.
To disassemble,
1. Turn the microwave oven over (FIG.
4-17).
2. Take off the
two
screws
which
fix the middle base board with a
"+"
- screwdriver and take off the middle cover (FIG.4
-18).
3. Loosen out the two screws of turntable motor with a
"+"-
screwdriver, take out the turntable motor and
puli
out the two
wires (4 -17).
Assembling steps:
1. Put the motor
shaft
into its connecting
hole,
and fix the motor
with two screws (FIG.4
-17).
2.
Pług
in the two wires.
3. Assemble and fix the middle base board with two screws
(FIG.4-18).
4. Turn the oven back.
5. As the FIG.4 - 19 shown, fix in the turntable shaft
supporter,
the place in the roller ring and the
glass
tray as FIG .4 - 20.
Fig.4-17
Fig. 4-18
turntable shaft supporter
roller ring
Fig. 4-19
© ©
o ©
&
<s>
©s©
4.10 THE DOOR
SAFTY
INTERLOCKS.
Firstly, do as the same with 1,
2,
3, steps of III of this part.
Steps for dismantling:
(1)
Puli
out the terminal
plugs
of the interlock switch and the pilot switch.
(2) Loosen out the two screws which fixed the switch holder with a
"+"-
screwdriver,
and take the switch
holder
off.
(3) Take off the interlock switch and the pilot switch
from
the holder.
(4) Take off the switch connecting lever
arm
and the working lever from the holder.
Assembling steps:
14
To Next Page
Loading...
